Amplifier Research 100A250 10KHz-250MHz, 100W RF Amplifier

•Frequency Response: 10 kHz – 250 MHz
•Rated Output Power: 100 watts
•Flatness: ± 1.5 dB maximum
•Gain (at maximum setting): 50 dB minimum
•Gain Adjustment (continuous range): 18 dB minimum
•Input Impedance: 50 ohms, VSWR 1.5:1 maximum
•Output Impedance: 50 ohms, VSWR 2.0:1 maximum
•Noise Figure (above 1.0 MHz): 10 dB typical

Artikelnummer: 1501 Kategorien: ,


The Amplifier Research 100A250 is a self contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The 100A250, when used with an RF sweep generator, will provide a minimum of 100 watts of swept power. There is a digital display on the front panel to indicate the operational status and fault conditions when an over temperature, power supply, or amplifier fault has occurred. The 100A250 can be returned to operational status when the condition has been cleared. The 100A250 includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions. The 100A250 provides readily available RF Power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for higher power amplifiers.

Zusätzliche Informationen



echo do_shortcode('[google-translator]');